Maintenance
Maintenance Agreement sof Service
McClaren 1 (Includes Winterization and Spring Start-Up)
McClaren 2 (Includes Winterization, Spring Start-Up and Summer Check-Up)
McClaren 3 (Includes Winterization, Spring Start-Up and 3 Periodic Check-Up's)
Winterization
Included in Services: Irrigation Off, McCLaren1, McClaren2, and McClaren3
Drainage and removal of water from the irrigation system only will be done using compressed air. The controller will also be turned off at this time. Winterizations are generally performed between 1st of October and threw the end of November depending on weather conditions.
Spring Start-Up
Included in Services: Irrigation On, McCLaren 1, McClaren 2, and McClaren 3
Turning water on and checking system for water flow and pressure; checking system for any leaks or broken pop ups; adjusting pop ups for proper rotation; programming controller and checking battery backup. The timer will be programmed and set to run based on current weather conditions, ready to be switched on and/or changed by customer as desired. Spring start-ups are generally performed between mid April and the end of June depending on weather conditions.
Summer Check-Up
Included in McClaren 2 Service
This is a scheduled visit during which McClaren Irrigation will recheck the system for proper water flow and pressure; check the system for any leaks and ensure proper head rotation. We will also raise or lower pop ups as necessary for growth in shrub areas and adjust the watering program schedule to support summer weather conditions.
Service Tune-Up
Included in McClaren 3 Service
This is a “McClaren Irrigation Preventative Maintenance Program”. Service visits will be scheduled threw out during the course of the season to inspect the system to insure that all areas are being watered correctly and all parts of the Irrigation system are working properly. Water usage will be reduced by ensuring that the irrigation system is running efficiently for the season, thereby providing a cost savings to you. These visits will include head adjustments, timer programming, nozzle cleaning and/or replacement if necessary. Note: Replacement parts must be approved by customer. An appointment must be scheduled for the periodic check-up visits.
An appointment must be scheduled for the periodic check-up visits.